Octopus V1.1 Control Board / Mainboard
🐙【Main control chip】Using 32-bit ARM Cortex-M4 series main control chip STM32F446ZET6 with core frequency of 180MHz.
🐙【Powerful DIY Support】This motherboard supports up to 8 stepper drivers with a total of 9 stepper driver outputs; And up to 6 PWM fans and 2 always-on fans with the ability to individually select which voltage rail will control each fan. Choose from Vin, 12V or 5V.
🐙【Motherboard expansion function】Support BLTouch, locked rotor detection, shutdown after printing, continue printing after power failure, CAN bus, U disk function, IIC expansion; at the same time reserved WIFI interface, PT100 thermistor interface (optional), dual Z-axis printer.
🐙【Features of TMC2209 Driver】TMC2209 stepper driver is not easy to lose steps and is in ultra-quiet mode; the module has a large heat sink area, which can reduce the temperature of the driver when it is working; the module supports three modes: STEP/DIRECT and UART.
🐙【TMC2209 Driver Mode】The TMC Motor Driver can be used in SPI or UART mode by simply adjusting the built-in jumpers below each motor driver. Additionally, you can connect or disconnect the TMC DIAG pin using a built-in jumper allowing you to use hard stops or sensorless guides without having to cut any pins.
***BIGTREETECH Octopus V1.1 control panel is used for 3d printers such as Voron 2.4 & Rat Rig & BLV…DIY
***BIGTREETECH Octopus V1.1 GitHub:
https://github.com/bigtreetech/BIGTREETECH-OCTOPUS-V1.0
**To get the best price, please contact the shop directly:
0913.939.775 contact A.Quan (for English)
094.144.0951 contact A.Quynh
**Selling price does not include VAT (+10% if VAT invoice is issued)
Reviews
There are no reviews yet.