3d printing resin eSun eResin-eLastic Transparent Yellow 0.5kg/Bottle

3d printing resin eSun eResin-eLastic elastic color Transparent Yellow 0.5kg/Bottle
_High elongation at break, good elasticity, tear, tensile, bending and compression resistance, fast recovery, certain wear resistance.
_Compared to eResin-Flex, the viscosity is significantly reduced to ensure the demolding and molding process.
_The release rate is relatively high and easy to print, the hardness is lower, and the molded parts are softer and more elastic; meanwhile, the bending performance is improved to make thick parts withstand more times and large angle bending. It can be used on product models that require softness.
+Good elasticity
+Tear resistant
+Anti-bending
+High toughness
+Low hardness
+Low viscosity

**Application: Mechanical, Automotive, Electronic equipment, Transport pipelines, Sports equipment…

**Plastic property table:
+3D PRINTING PHOTOPOLYMER RESIN eResin-Elastic
+Viscosity(mPa·s) 500-900
+Density(g/cm3) 1.080-1.085
+Tensile Strength(MPa) 4-5
+Elongation at Break(%) 250-350
+Flexural Strength(MPa) /
+Impact Strength(J/m) /
+Tearing Strength(GPa) 8-10
+Heat Distortion Temp(℃) /
+Hardness(Shore D) 70A

Grades (out of 10)
+Strength（S） 2
+Toughness（F） 10
+Forming（P） 4
+Accuracy（S） 6
+Speed （A） 2

**Note:
1. Shake well before printing
2. Slice settings:
Stronger Support: Break Avoild with Main Body
Denser support： Avoid dislocation deformation

3.Printing data
+Higher lifting distance: full film realse
+Lifting distance：≥6mm
+Slowing down Lifting speed: avoid breaking
+Lifting speed: ≤60mm/min
+Control leveling time: full leveling
+Light off delay ≥ 6s

4.Post Curing
Reasonable control of curing time, the longer the contact time, the higher the hardness of the curing material, the lower the plasticity, and the more severe the yellowing.
To ensure good flexibility of the material and avoid post-curing hardening problems, it is recommended to clean the printed parts after printing instead of post-processing.
The sticky condition on the surface will gradually improve in low light conditions indoors. Avoid exposure to strong light for future preservation.

**For further support on product price and information, please contact:
0913.939.775 contact A. Quan (for English)
094.144.0951 contact A.Quynh
**Selling price does not include VAT (+10% if VAT invoice is issued)